rigenerazione forzata dpf e misure

penso sia molto utile

« Older   Newer »
 
  Share  
.
  1. totalcupra
     
    .

    User deleted


    Penso sia molto utile... oltre alla rigenerazione si riescono a leggere alcuni valori molto importanti.


    Diesel Particle Filter Emergency Regeneration
    From Ross-Tech Wiki
    Jump to: navigation, search
    Contents [hide]
    1 1.4l/1.9l/2.0l R4 & 2.5l R5 PD/PPD-TDI
    2 3.0l V6 CR-TDI


    1.4l/1.9l/2.0l R4 & 2.5l R5 PD/PPD-TDI
    Prerequisites (General):


    Ignition ON
    Engine ON (Idle)
    Coolant Temperature above 50 °C (see MVB 002.4)
    Particle Filter Load below Specification (see MVB 075.3, VAG-COM should give the specified value)
    If the Particle Filter Load is above Specification the Particle Filter needs to be replaced since the car may burn down when regenerating.
    Power Consumers ON (Light, Seat Heating, Front/Rear Window Heater, Climate Control)
    Conditions (Driving Cycle):


    Vehicle Speed between 30-60 km/h (18-37 MPH)
    Engine Speed between 1500-2500 RPM (4th or 5th Gear, Automatic Transmission in Tiptronic)
    Duration approx. 15-20 Minutes
    Exhaust Gas Temperature before Turbo Charger above 700 °C
    Drive the car based on the above conditions until the Particle Filter Load is as low as possible (close to 0 %). In case the regeneration fails there can either be problems with the Driving Cycle Conditions or with the Engine Hardware.

    [Select]
    [01 - Engine]


    [Coding-II - 11]


    Enable Regeneration by Entering 21295.
    [Do It!]


    [Meas. Blocks - 08]
    Select both Groups at once 070 and 075.
    [Go!]
    MVB 070.1: Regeneration Status (xxxxxxx1 = Normal Regeneration active, xxxxxx1x = Forced Regeneration active)
    MVB 070.3: Regeneration Counter/Timer
    MVB 075.1: Exhaust Gas Temperature before Turbo Charger
    MVB 075.2: Exhaust Gas Temperature before Particle Filter
    MVB 075.3: Particle Filter Load
    MVB 075.4: Exhaust Gas Temperature after Particle Filter


    Now Start the Driving Cycle and keep watching the Measuring Blocks (2nd Person required).


    [Done, Go Back]
    [Close Controller, Go Back - 06]


     
    .
  2. Ale-S3
     
    .

    User deleted


    Tramite vag che canale devi leggere per avere tutti i valori ?
     
    .
  3. totalcupra
     
    .

    User deleted


    devi entrare in engine e poi canale 8.

    Ciao
     
    .
2 replies since 4/4/2008, 14:18   854 views
  Share  
.